An up-to-24-bit parallel RGB interface is available on all Raspberry Pi boards with the 40 way header and the. It is possible to enable an early stage UART to debug booting issues (useful with the above bootcode.bin only boot mode). OctoPrint provided by Prusa Research is tested and is confirmed to be booting correctly. Mechanical drawings for the Raspberry Pi 3 Model A+ are also applicable to the Raspberry Pi 1 Model A+. If the Octoprint webpage loads, you can continue. If octopi.local doesn't work, please use the following steps: Check your router for a new IP address, using an app like Fing, or wait until the address is displayed on the printer's display.Īs soon as you have the IP, open a web browser on your PC, type it in, and hit Enter. Then open the browser and try opening a website: octopi.local. The RPi Zero is not a superfast computer and it needs time to boot. Go to the printer's LCD menu -> Settings -> RPi port, and make sure it is set to ON. Notice that the position of the support pin is in the corner ( purple arrow). Make sure the RPi Zero is properly installed by inspecting the connector on the other side of the Einsy Rambo ( green arrows).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |